More Juice on the J6

Further progress has the chassis together and ready for the fitting of the hornblocks. 

Despite the quite substantial frames there was still a bit of flex in between the two main spacers and the rear one which is just soldered to the top left the bottom of the chassis with a tendency to splay outwards. To get over this I have temporarily soldered a third frame spacer (labeled motor spacer in and I also cut one of the wider frame spacers down and soldered it upright to take out the splay at the rear. 

As is comes there are three sets of spacers, marked from when it was blown up from a 4mm kit 00 gauge, EM gauge and P4 I am using the EM gauge spacers as a compromise between getting int to go around 5′ curves and having having sufficient room to fit the inside motion.

 

Gladiator J6 – Loco Chassis

Gladiator J6 – Loco Chassis

Before I go any further I am going to rework the springs and fit them before adding the Horn guides.