Something to renew the modelling mojo

A lot has been going on at work recently which has reduced my modelling mojo with regard to the 06 (and modelling in general) . So I decided that I might try something different and that something being my Metalsmith turntable kit.

It’s for a Ransomes and Rapier 70′ table and this is what you get in the kit. This is the kit itself and the additional turntable installation kit.

This is how far I got in a very short space of time. The nickel spacers were folded up and soldered. and a couple of bearings were soldered into the centre bottom spacer. The rest just screws together…

After dinner I will start on the riveted angle plates. I expect that these will take a little longer to make progress.