I have managed to make steady progress over the festive period despite the setback of a power cut all day on Christmas Eve.

I now have all the oilers repiped and soldered to their respective brackets or direct to the footplate.

This was the setup that I used to solder the pipes into the rear of the bracket mounted two port oilers. An oak block with a hole drilled in it to accommodate the leadscrew f the handvice. The hole is quite a snug fit so that when the block is clamped to the bench the vice itself doesn’t move. The brackets were clamped in the vice with a piece of square bar supporting them which seemed to make up for the third or fourth hands that I could have done with when soldering pipes to the others.

I won’t fit the bracket mounted ones until I have the firebox and boiler fitted in the next couple of days or so. I have also done work on a few other details but I am not ready to share them yet as they aren’t completed yet.