I have also got a number of other bits near to being finally assembled.

Frame spacers, I found another two or three in the box afterwards but you get the drift.

Inner cab rear with locker and coal chute door.

Inner tanks

Rear cab lockers and horn guides

Inner cab roof. I didn’t attempt to roll the outer roof without rolling bars I managed to do the inner with just manipulation between my fingers and the edge of the cutting mat.

Cab floor and front lockers/rear splashers

Frames. I had marked and cut out roughly for the horn guides and was painstakingly filing them when I thought it would be much easier to mill them slightly but accurately over size so that I can use my chassis jig to fit them. I also invested in a set of Premier joined rods.