Not too much done on the J6 this week but it’s almost there now.

I had a bit of a fright when I fitted the motor and I couldn’t get the body on but thankfully I had just put it in the wrong way round.

What it did need is a motor mount/steady to stop it moving backwards and forwards inside the body. I cut a small piece of nickel sheet as a slding fit between the frames and then cut out the mounting hole. I worked out where I needed to fold it and then decided to give the bending shear on the MiniFormit a try. I am pleased o say it bend it perfectly. Not being used to using it, to make bends. I didn’t follow the bend through to a right angle. instead I finished it off in my hold and fold.

I just need to solder it in now.