“Cabbing the A3”

I have now completed the cab for the A3 (I think!).

As mentioned earlier in the thread I have now made the roof removable and following the lead from a gent on the Guild forum I have made the cab doors hinged and removable.


IMG_5700 IMG_5701 IMG_5703 IMG_5702

The hinge pins are made from 0.8mm nickel rod with small section of tube soldered on one end and then filed down.

IMG_5704 IMG_5705 IMG_5706

Now for a good clean up and a final check to make sure that nothing is missing before re-visiting the paint shop – The seats will be added when it’s assembled after painting I looked at soldering them in now but if I do I cannot get the backhead in…. (hmm I have been here before!)